How To Turn The Power On Or Off - Furuno FCV-1900 Operator's Manual

1. OPERATION
No. Key
6
3
7
,
8 RANGE
9 GAIN
10 SHIFT
11 VRM
12 ENTER knob
13 MENU/ESC
14 MODE
15, 16 F1, F2
1.2

How to Turn the Power On or Off

Press the
following sequence: FURUNO display → model display, then the last-used display is
shown. When the key brilliance is set to other than "0", the power lamp above the key
lights.
To turn off the power, press the
until power off is counted down on the screen.
Note 1: Do not turn off the ship's mains when the processor unit is running. The setting
values may not be saved properly.
Note 2: The processor unit consumes electric power when the power is off (stand-by
power consumption: 0.06 A). It is recommended to turn off the fish finder at the ship's
mains if you will not be using it for some time.
1-2
For FCV-1900G
• Short press: Switch the setting direction between lengthwise direction
(depth) and cross direction (time) when the measuring mode is [Specific
Area].
• Long press: No function.
For FCV-1900 and FCV-1900B
• Short press: Execute assigned program.
• Long press: Open the menu to assign the function.
For FCV-1900G
• Adjust the measuring area when the measuring mode is [Specific Range],
[Bottom Trace], or [Specific Area].
For FCV-1900 and FCV-1900B
• Adjust the display range.
Assign the range control function to the ENTER knob.
Assign the gain control function to the ENTER knob.
Assign the shift range control function to the ENTER knob.
• Assign the VRM and TLL control functions to the ENTER knob.
• Switch the VRM key's mode: VRM mode and TLL mode.
Rotate • Adjust the display range, gain, VRM, TLL line, or shift range.
• Move the cursor*.
• Adjust setting value*.
*: Clockwise rotation increases the value and moves the cursor
downward and rightward. Counterclockwise rotation decreases
the value and moves the cursor upward and leftward.
Short • Confirm the selection.
press • Output the TLL information to a chart plotter.
Long • Activate the scroll back mode.
press
• Open/close the menu.
• Escape from current operation.
Open the [Mode] window to select the display mode.
Short press: Execute assigned program.
Long press: Open the [FUNC] tab to assign the function.
key to turn on the power. A beep sounds and the display changes in the
Description
key more than three seconds. The time remaining