Replacing The Lamp; Indicators - Mitsubishi X100 Owner's Manual

Indicators / TEMP, LAMP, POWER
The projector has three indicators each of which shows the working condition of the projector.
• Though the LAMP and TEMP indicators are on the main menu control window of PCGC, the each
indicator may not match the one of those on the control panel.
The following offers solutions to possible problems. If a problem persists, turn the projector off
and consult your dealer.
INDICATOR
TEMP
INDICATOR
LAMP
INDICATOR
POWER
INDICATOR
50
LAMP TEMP
FREEZE
SOURCE
/CAPTURE
SHOWS
• Unusual temperature
The power is turned off
and the POWER indicator
lights up red.
• The ventilation slots or air
filter is clogged with dust
or debris.
• The fan has stopped due
blinking red
to an impediment.
• The location temperature
is too high.
• The filter is dirty.
Steady green Normal
Blinking red
Lamp is almost used up.
• Lamp is used up.
Steady red
The power is not turned on.
•
(Power indicator lights up red.)
Steady red Standby
Steady green
Power-on
CONDITION
POSSIBLE SOLUTIONS
• Remove the object from
the ventilation slot.
• Pull out the power
plug and remove the
object. If you cannot,
consult your dealer.
• Relocate the projector
to a cooler place.
• Clean the filter.
-
Replace the lamp.
Exchange with a new
lamp if the same
problem recurs.
-
-