Mitsubishi X100 Owner's Manual page 29

SUPER
SUPER
IMPOSE
IMPOSE
(Picture in
Picture)
RETURN
SOURCE
Selects the desired input source of the sub-image. Select the desired input source
by pressing the ª or º buttons on the control panel (or { or } buttons on the
remote control).
FRAME
Selects the desired position of the sub-image. Select the desired position by pressing
the ª or º buttons on the control panel (or { or } buttons on the remote con-
POS
trol).
FRAME
Selects the desired size of the sub-image. Select the desired size: small, middle or
large by pressing the ª or º buttons on the control panel (or { or } buttons on
SIZE
the remote control). Selecting No. 5 of FRAME POS doesn't change the frame size.
SOURCE ID
Use to set SOURCE ID on or off. If you select OFF, the mode display automatically
disappears after about four seconds. If you select ON, the mode display continues to
appear. The SOURCE ID is automatically set to OFF, when the power is turned off.
BLUE BACK
Use to set BLUE BACK on or off. When there is no input signal, the projector
displays a blue screen. Select OFF if you don't want to display a blue background.
(VIDEO MUTE)
TEST
Use to display the built-in test pattern on the screen. There are five different
patterns. Select the desired pattern by pressing the ª or º buttons on the control
PATTERN
panel (or { or } buttons on the remote control).
Important:
To make the test pattern disappeared, press the buttons except FOCUS/ZOOM, + or
- buttons while the MENU display in not on screen.
FRAME FRAME
SOURCE
POS SIZE
VIDEO1 1 1
VIDEO2 2 2
RGB1 3 3
RGB2
4
PC1
5
PC2
RESET
29