Mitsubishi X100 Owner's Manual page 11

PC analog RGB input
Use to input video signals (analog RGB) of a personal computer.
(Pin assignment of Mini D-SUB 15P jack)
PIN NO. SPEC
1 R(RED) / Cr
2 G(GREEN) / Y
3 B(BLUE) / Cb
4 GROUND
5 GROUND
6 GROUND
7 GROUND
8 GROUND
RS-232C input
• Connect here when you control this Projector with a personal computer
using PCGC (personal computer graphic controller) or with a remote
controller using SpacePointer function.
• The Pin assignment is DTE (Data Terminal Equipment) type.
• Please use RS-232C crossover cable provided.
(Pin assignment of D-SUB 9P jack)
PIN NO. CODE
1 CD
2 RD
3 SD
4 ER
5 SG
6 DR
7 RS
8 CS
9 CI
Bottom side
PIN NO.
9
10
11
12
13
14
15
NAME
Carrier Detect
Receive Data(RXD)
Send Data(TXD)
Equipment Ready(DTR)
Signal Ground
Data Set Ready(DSR)
Request to Send(RTS)
Clear to Send(CTS)
Ring Indicator
SPEC
-
GROUND
GROUND
-
HD/CS
VD
-
I/O
INPUT
connected to inner circuit
INPUT
connected to inner circuit
OUTPUT
connected to inner circuit
OUTPUT
connected to inner circuit
connected to inner circuit
OUTPUT
connected to inner circuit
OUTPUT
connected to inner circuit
INPUT
INPUT
foot adjustment
Use to adjust the angle of the projector.
See page 15.
Note: Be sure to retract them when
packing up the projector.
ventilation slots
Used to protect the projector from overheating.
See page 47.
ventilation air filter
This prevents dust from entering inside the
projector. See page 47.
5 1
10
15 11
1
6 9
NOTE
not connected
not connected
6
5
11