Separate Uhf And Vhf Antennas; Analog Antenna, Wall Outlet Cable, Or Cable Box; Analog Antenna, Wall Outlet Cable Or Cable Box - Mitsubishi WS-73909 Owner's Manual

Part II: Installation
Connecting an Analog Antenna, Wall Outlet Cable, or Cable
Box

Separate UHF and VHF Antennas

(Figure 1)
1
Connect the UHF and VHF antenna
leads to the UHF/VHF combiner.
2
Push the combiner onto ANT-A on the
TV back panel.
UHF/VHF combiners are not provided
with the TV. They should be available at
most electronic stores.
Mitsubishi strongly recommends against using antennas with
twin a t le ads. T wi n a t le a d an t en na wir e s are su bj ec t to
interference which may adversely affect the performance of the
TV. We recommend using coaxial antenna cable.
Antenna or Wall Outlet Cable for
Analog Broadcasts.
(Figure 2)
For antennas with twin a t le ad
1
For antenna with twin a t le ads, co nnect
the 300-Ohm twin leads to the trans-
former.
2
Push the 75-Ohm side of the transformer
onto ANT-A on the TV back panel.
300-Ohm to 75-Ohm matching trans-
formers are not provided with the TV.
They should be available at most elec-
tronic stores.
For cable or antenna with coaxial lead
3
Connect the incoming cable to ANT-A on
the TV back panel.
Mitsubishi strongly recommends against using antennas with
twin a t le ads. T wi n a t le a d an t en na wir e s are su bj ec t to
interference which may adversely affect the performance of the
TV. We recommend using coaxial antenna cable.
Cable Box
(Figure 3)
1
Connect the incoming cable to ANT-A on
the TV back panel.
Connect two coaxial cables as follows:
One from LOOP-OUT on the TV back panel to
2
IN on the cable box back panel.
3
One from OUT on the cable box back panel to
ANT-B on the TV back panel.
18
18
UHF Antenna
VHF Antenna
(Channels 14-69)
(Channels 2-13)
Flat Twin Lead
Flat Twin Lead
TV back panel
External
Antenna
or Cable
300 Ohm to
75 Ohm
Combiner
UHF
2
VHF
Side
Back
1
Figure 1. Connecting separate UHF and VHF antennas.
300 Ohm Flat 75 Ohm
Twin Lead Coaxial Cable
1
Optional 300 Ohm to 75 Ohm
Matching Transformer
Figure 2. Connecting antenna or wall outlet cable for
analog broadcasts.
Incoming
Cable
IN
Figure 3. Connecting the cable box.
TV back panel p
1 2
3
2
10
TV back panel
11
5
1 2
6
12
9
1 3
8
4
2
3
Cable Box
back panel section
OUT
7