Appendix B Status Command Fields - Symmetricom ATS-6511A User Manual

Appendix B Status Command Fields

This section provides information on the results from the status command.
ATS-6511B>status
[alarm] no alarm
[fiber]
[chassis_delay] -3.000000000000000e-10
[clock_offset] 9.497872340000000e-09
[da4340delay] 0.000000000000000e+00
[fpga]
[delay] 0.000000000000000e+00
[inputA] good
[inputB] good
[steer] -1.000000000100000e-12
[two_way]
[channelA]
[4340_output] 0
[clock_offset] 1.000000001111078e-10
[direct_connect] true
[fiber_delay]
[local] 6.887777777811110e-08
[remote] 6.335555555555556e-08
[remote_tdc_time] 2011-11-07-18:07:55
[rxdelay] -3.690000000000000e-08
[txdelay] -3.690000000000000e-08
[channelB]
[4340_output] 0
[clock_offset] -6.601419878215690e-09
[direct_connect] true
[fiber_delay]
[local] 5.368593644378431e-08
[remote] 7.398039215686274e-08
[remote_tdc_time] 2011-11-07-18:07:57
[rxdelay] -3.650000000000000e-08
[txdelay] -3.650000000000000e-08
[hardware]
[fan]
[1] true
[2] true
[mainboard]
[EUID] 00:a0:69:00:03:00:00:f8
[serialnum] 164233
[type] 6511
[outputs]
[enabled] true
[slots]
[1]
[ports]
[1]
[status] good
[2]
[status] good
[3]
[status] good
[4]
ATS-6511A/B/C Users Guide
Highest priority alarm.
Fiber Information
Chassis Calibration Value
Current Clock offset from the source
Fiber Dist Amp Delays
Internal Delays
Input A Status
Input B Status
Clock Steer value
Two Way Data Exchange Information
Fiber A
0 = no 4340, # = 4340 Channel
Current Fiber offset.
True = no 4340 in the path.
Measured fiber delays
Fiber length in nSec.
Fiber length reported by 6501.
Time measurement was made.
Factory Calibration values
Fiber B (same as A)
System Information
Fan Status
Fan 1
Fan 2
Unit Information
Main Board Electronic ID
Unit S/N
Model #
Outputs
On=Enabled, Off=Disabled
Output Card Information
Slot #
Port Information
Port #
Port Status
66
DOC 6511_Release K