Irig Outputs - Symmetricom ATS-6511A User Manual

[type] pps
[3]
[format] B
[signal_word] 0
[type] irig
[4]
[format] B
[signal_word] 0
[type] irig
To check the status of the output card use the status hardware:outputs:slots:N command (N=Card
Slot #) to verify the card status.
[ports]
[1]
[status] good
[2]
[status] good
[3]
[status] good
[4]
[status] good
[power] enabled
[type] 4394A

6.2.7 IRIG Outputs

The ATS-6511 is capable of providing different DC IRIG outputs on each port of the 4394A card
and AM IRIG outputs on the 4387A card. By default ports #3 and #4 on the 4394A card are set
to B000. The 4387A outputs are set to B120 by default. Users can modify these settings. Users
are cautioned to ensure they connect the correct cables to the correct output ports to avoid any
problems.
To verify the settings use the settings hardware:slots:N command (N=Card Slot #) to verify the
system settings.
ATS-6511> settings hardware:slots:1
[tsc4373]
[ports]
[1]
[pps_period] 1
[pps_width] 1.000000000000000e-04
[type] pps
[2]
[pps_period] 1
[pps_width] 1.000000000000000e-04
[type] pps
[3]
[format] B
[signal_word] 0
[type] irig
[4]
[format] B
[signal_word] 0
[type] irig
ATS-6511A/B/C Users Guide
54
DOC 6511_Release K