Status Port (1900) - Symmetricom ATS-6511A User Manual

Diagnostic messages are only displayed on the diagnostic port. If users wish to save the messages
provided by the diagnostic port then the output of this port must be saved to a file. It is
recommended that diagnostic messages be saved only to remote systems and not locally on the
ATS-6511. Storing files locally may cause the file system to exceed its storage capacity and the
ATS-6511 will no longer operate.
The options for the diagnostic outputs include error, info, or debug messages from the,
subsystems listed below. To determine the current settings telnet into the command port and use
the settings diaglog command.
ATS-6511B>settings diaglog
[cpld4370] info
[fiber] info
[kas2] info
[lnsrawstate] info
[software] info
[switching] info
[timecode] info
[tsc4370] info
[tsgather] info
[warmstart] info
[OK] 2013-08-13T18:24:37Z
To change the settings use the diag command then specify which message types (error, info, or
debug) you would like to see for the desired subsystem. Example – if you want to look at the
debug messages for the kas2 use the diag kas2 debug command. You can verify this by using the
settings diaglog command.
ATS-6511>diag kas2 debug
[OK] 2013-08-13T18:25:48Z
ATS-6511>settings diaglog
[cpld4370] info
[fiber] info
[kas2] debug
[software] info
[switching] info
[timecode] info
[tsc4370] info
[warmstart] info
Users can modify these settings as needed and are able to save these settings to the default start
up if desired by typing save. These settings can also be saved to a different configuration file if
desired by typing save and providing a configuration filename.
3.4.3.3

Status Port (1900)

This port provides users with real time system status updates. As the fields that are displayed
using the config, settings, status, and network commands are updated internally they are
forwarded to this port in real time. Users wanting to display system parameters, measurements,
ATS-6511A/B/C Users Guide
32
DOC 6511_Release K