4399A (L-Band Bpsk Module) - Symmetricom ATS-6511A User Manual

The system will generate an error message if the operator attempts to enter an
unsupported or invalid code.
To verify the settings use the settings hardware:slots:N command (N=Slot #) to obtain
the current settings for a particular card.
ATS-6511> settings hardware:slots:5
[tsc4387]
[ports]
[1]
[format] B
[signal_word] 120
[type] irig
[2]
[format] B
[signal_word] 120
[type] irig
[3]
[format] G
[signal_word] 141
[type] nasa36
[4]
[format] B
[signal_word] 120
[type] irig
[OK] 2013-08-13T14:35:35Z
To verify the card is working properly use the status hardware:outputs:slots:N command (N=Slot
#) to obtain the current settings for a particular card.
ATS-6511>status hardware:outputs:slots:5
[ports]
[1]
[status] good
[2]
[status] good
[3]
[status] good
[4]
[status] good
[power] enabled
[type] 4387A
[OK] 2013-08-13T14:36:00Z

2.4.2.6 4399A (L-Band BPSK module)

This module provides four RF outputs and one 1 PPS output on SMA connectors and is
controlled via the 9 pin RS-232 located on its panel. The 4399A serial interface is via RS-232, at
115200 baud, 8-N-1, with flow control set to "none". The serial interface is the means for issuing
commands to the module as well as sending the file containing the BPSK bit pattern. Commands
are case-sensitive. The BPSK bit pattern file can be sent to the board using Hyperterminal or any
other communications program that supports the XMODEM protocol.
To send the bit pattern file using Hyperterminal, follow these instructions:
ATS-6511A/B/C Users Guide
12
DOC 6511_Release K