Attachment Options For The Pd-5010 Monitor - Mitsubishi PD-5010 Owner's Manual

Attachment Options for the PD-5010 Monitor

You can attach your optional mounts or stand to the plasma
monitor in one of the following two ways:
* While it is upright. (See Drawing A)
* As it is laid down with the screen face down (See Drawing
B). Lay the protective sheet, which was wrapped around
the monitor when it was packaged, beneath the screen
surface so as not to scratch the screen face.
• This device cannot be installed on its own.
Be sure to use a stand or wall mount kit.
* See page 2.
• For correct installation and mounting it is
strongly recommended to use a trained,
authorized Mitsubishi dealer.
Failure to follow correct mounting procedures
could result in damage to the equipment or
injury to the installer.
Product warranty does not cover damage
caused by improper installation.
* Use only a matching stand or wall mount kit
designed to fit this product.
Ventilation Requirements for
enclosure mounting
To allow heat to disperse, leave space between
surrounding objects as shown on the diagram at the
right, when installing.
1