Format Operation With Computer Signals - Mitsubishi PD-4265 Owner's Manual

Format Operation with Computer
Signals
Switch to the wide screen mode to expand the 4 : 3 image
to fill the entire screen.
1. Press the FORMAT button on the remote control.
2. Within 3 seconds ...
Press the FORMAT button again.
The screen size switches as follows:
→ NARROW → STANDARD → EXPAND
NARROW screen size (4:3 or SXGA 5:4)
The picture has the same size as the normal computer
image.
STANDARD screen size
The image is expanded in the horizontal direction.
EXPAND screen size
When wide signals are input.
STANDARD screen size
Information
Supported resolution
See page 34 for details on the display output of the
various VESA signal standards supported by the display.
When 852 (848) dot
signals with a vertical frequency of 60 Hz and
horizontal frequency of 31.7 (31.0) kHz are in-
put
Select an appropriate setting for RGB SELECT
mode referring to the"Table of Signals Supported"
on page 34.
* "VGA", "SVGA" and "SXGA" are registered
trademarks of IBM, Inc. of the United States.
WARNING
DO NOT OPERATE THE PLASMA DISPLAY IN NARROW
(4:3) SCREEN SIZE MODE FOR AN EXTENDED
PERIOD. THIS CAN CAUSE PHOSPHOR BURN-IN.
14
480 line wide VGA*