Listening To The Radio; Auto Preset Memory; Auto Tuning; Manual Tuning - Denon avr-2106 Operating Instructions Manual

ENGLISH
Basic Operation

Listening to the radio

FUNCTION BAND
ON/STANDBY SHIFT
POWER

Auto preset memory

• This unit is equipped with a function for automatically searching
for FM broadcast stations and storing them in the preset
memory.
• The "Auto tuner preset" operation can also be performed at
"System setup" ( page 38).
PRESET •
Hold the button and press the
switch on the main unit.
• The unit automatically begins searching for FM broadcast
stations.
When the first FM broadcast station is found, that station is
stored in the preset memory at channel A1.
Subsequent stations are automatically stored in order at
preset channels A1 to A8, B1 to B8, C1 to C8, D1 to D8, E1
to E8, F1 to F8 and G1 to G8 for a maximum of 56 stations.
Channel A1 is tuned in after the auto preset memory
operation is completed.
• If an FM station cannot be preset automatically due to poor
reception, use the "Manual tuning" operation to tune in the
station, then preset it using the manual "Preset memory"
operation.
• To interrupt this function, press the ON/STANDBY switch.
PRESET
TUNING
2 DEFAULT SETTINGS
A1 ~ A8
B1 ~ B8
C1 ~ C8
POWER
D1 ~ D8
E1 ~ E8
F1 ~ F8
G1 ~ G8

Auto tuning

1
Set the input source to "TUNER".
2
Watching the display, press the
select the desired band (AM or FM).
TUNING
TUNER
BAND
MEMORY PRESET
MODE SHIFT
ON SCREEN
Auto tuner presets
87.5 / 89.1 / 98.1 / 108.0 / 90.1 / 90.1 /
90.1 / 90.1 MHz
522 / 603 / 999 / 1404 / 1611 kHz,
90.1 / 90.1 / 90.1 MHz
90.1 MHz
90.1 MHz
90.1 MHz
90.1 MHz
90.1 MHz
(Main unit) (Remote control unit)
BAND
button to
27
ENGLISH
3
MODE
Press the button to set the auto tuning
mode.
4
TUNING
Press the (+) or (–) button.
Automatic searching begins, then stops when a station is
tuned in.
• When in the auto tuning mode on the FM band, the "STEREO"
indicator lights on the display when a stereo broadcast is tuned
in. At open frequencies, the noise is muted and the "TUNED"
and "STEREO" indicators turn off.

Manual tuning

1
Set the input source to "TUNER".
2
Watching the display, press the
select the desired band (AM or FM).
3
MODE
Press the button to set the manual tuning
mode.
Check that the display's "AUTO" indicator turns off.
Basic Operation
BAND
button to