Wireless Tab - Setting Of Wireless Connection - Sony IPELA SNC-P5 User Manual

Subnet mask
Type the subnet mask.
Default gateway
Type the default gateway.
Obtain DNS server address automatically
Select this to obtain the address of DNS server
automatically. It can be set only when Obtain an IP
address automatically (DHCP) is selected.
Note
When you select Obtain DNS server address
automatically, make sure that DHCP server is active on
the network.
Use the following DNS server address
Select this when you set the fixed address as the IP
address of DNS server.
Primary DNS server
Type the IP address of the primary DNS server.
Secondary DNS server
Type the IP address of the secondary DNS server, if
necessary.
Host name
Type the host name of the camera to be transmitted to the
DHCP server. This setting is valid only when Obtain an
IP address automatically (DHCP) is selected in the
Network tab.
Domain suffix
Type the domain suffix of the camera to be transmitted
to the DHCP server. This setting is valid only when
Obtain an IP address automatically (DHCP) is
selected in the Network tab.
Note
The domain suffix is sent to the DHCP server as FQDN
(Fully Qualified Domain Suffix) information when Host
name is set.
HTTP port number
Normally select 80. If you want to use a port number
other than 80, select the text box and type a port number
between 1024 and 65535.
Note
When you have set the HTTP port number to a number
other than 80 in the Network setting menu or in the IP
44
Configuring the Network — Network setting Menu
Setup Program, access the camera again by typing the IP
address of the camera on your Web browser as follows:
Example: when HTTP port number is set to 8000
OK/Cancel
See "Buttons common to every setting menu" on page
34.
Wireless Tab — Setting of Wireless
Connection
Insert the specified wireless LAN card into the CF card
slot of the camera, and set the matters to connect to the
wireless network.
Use Wireless card SNCA-CFW1 (optional) for the
wireless LAN card. For a wireless long-range sending
and receiving, use the wireless antenna SNCA-AN1
(optional) that can be connected to SNCA-CFW1.
Note
If you use the wireless function of this unit, set a
network address defined by the IP address, subnet mask
and default gateway in the Wireless tab. In this case, the
network address should be different from the priority
connection set in the Network tab.
MAC address
Displays MAC address of the wireless LAN card
inserted to the CF card slot.
If any wireless LAN card is not inserted,
"00:00:00:00:00:00" is displayed.