Invacare® Leo
5.
Remove the existing drive wheel assembly from the drive shaft.
Use a wheel puller if necessary to remove the wheel
from the drive shaft.
6.
Remove the large washer F from the drive shaft.
7.
Remove keystock G from drive shaft. Set aside.
8.
If necessary, repeat STEPS 3 - 6 to remove other drive wheel.
Installing the Drive Wheels
Place keystock G in cutout on drive shaft E as shown in the
1.
illustration above.
The keystock in the drive shaft MUST lineup with the
cutout in the wheel hub.
If necessary, use a rubber hammer to gently tap drive
wheel completely into position on the drive shaft.
Install the large washer F onto the drive shaft.
2.
Install the drive wheel A onto the drive shaft.
3.
4.
Secure wheel to drive shaft by installing the small washer D and
locknut C onto the threaded end of the drive shaft. Securely
tighten.
Install the cap B.
5.
6.
Repeat STEPS 1-5 to install the other drive wheel.
7.
Install the seat. Refer to 5.5 Removing/Installing the seat, page 20.
9.4.2 Removing/Installing the Front Wheel - Three
Wheel Models
Take note of position and orientation of wheel and mounting
hardware before removing.
Reverse this procedure to install the front wheel.
40
Tools:
•
12 mm spanner
•
13 mm spanner
•
13 mm safety nut
1.
Turn power off and remove the key from the ignition.
2.
Place the front of the scooter up on blocks so that the front
wheel is off the ground.
3.
Remove the bolt A, axle B, washer C, nut D and two spacers
E that secure the wheel F to the fork G.
4.
Remove the wheel from the fork.
9.4.3 Removing/Installing the Front Wheels - Four
Wheel Models
Take note of position and orientation of wheel and mounting
hardware before removing.
Tools:
•
17 mm spanner
•
Rubber mallet
•
Screwdriver
•
17 mm safety nut
1506942-P