FIGURE 9.1 Removing/Installing the Drive Wheels
Removing/Installing the Front Wheel
NOTE: For this procedure, refer to FIGURE 9.2.
NOTE: Take note of position and orientation of wheel and mounting hardware before removing.
Removing
1. Turn power off and remove the key
from the ignition.
2. Place the front of the powered scooter
up on blocks so that the front wheel is
off the ground.
3. Remove the mounting screw, locknut
and two (2) spacers that secure the front
wheel to the fork.
4. Remove the front wheel from the fork.
Installing
1. Align the front wheel with the fork mounting hole.
2. Using the mounting screw, locknut and two (2) spacers, secure the front wheel to the
fork.
3. Securely tighten the front wheel mounting hardware.
Part No. 1125053
SECTION 9—WHEELS AND CASTERS
Scooter Frame
Drive
Shaft
Keystock
Fork
Mounting
Hole
Spacer
Locknut
FIGURE 9.2 Removing/Installing the Front
37
Warning: Pinch
Point
Drive Wheel
Washer
Mounting
Screw
Fork
Mounting
Screw
Spacer
Front
Wheel
Wheel
Zoom 220