Cleaning Flue Gas Deflector Section; Cleaning The Pellet Container; Checking Door Seal; Bearings - RIKA INDUO Operating Manual

Cleaning flue gas deflector section
Lift the cover of the stove by carefully pressing upwards and place it on a soft,
clean base.
Open the fixing bolts of the top cover plate and place it on a soft, clean base.
Open the fixing bolts of the cast cover.
Turn the cast cover carefully out of the frame and place it down.
Remove the top sheet steel deflector.
Vacuum out the deflector section.
Re-assembly the parts removed in reverse order.

Cleaning the pellet container

Do not refill the completely empty container immediately; remove the residues
(dust, chippings etc.) from the empty container. The unit must be disconnected
from the mains!
#8

Checking door seal

annually
The condition of the seals at doors and glass should be checked at least once
a year. Repair or replace seals depending on condition.
Note
Only intact seals ensure your stove works perfectly.

Bearings

annually
#6
All built in bearings (pellet screw, turning grid) should be checked. Clean or
replace bearings depending on condition.
Cleaning the flue gas channels
annually
Remove the flue pipes. Inspect and clean chimney connection. Brush off any
soot and dust deposits in the fire and in the flue pipes and vacuum.
Note
Accumulated fly ash in the flue gas channels may impair the performance of
the stove and pose a safety risk.
|31
30