Table of Contents
Advertisement
10. MODES
Note
When operated correctly, your stove can not overheat. Improper operation
may shorten the life expectancy of electrical components (blowers, motors
and electric control) and is not allowed!
Pellet Operation Manual/Automatic/Comfort
The
recommended
heat
output
50% -100%. If you want to select a lower heating power, stay for about 2
seconds on the MINUS button. Then you can adjust the heat output in the range
between 30% and 50%.
Tip
Within the recommended range of 50% - 100% output the sooting of the
combustion chamber and door glass is dramatically reduced.
MANUAL MODE
The pellet burner start and stop (ON / OFF buttons) and set the desired heat
output (PLUS / MINUS buttons) can be done on the touch screen directly at the
HOME main menu.
AUTOMATIC MODE
The change from the operating status "STOVE OFF" to STANDBY-status (ON
button) and from STANDBY-status to STOVE OFF (OFF button) is made by
pressing the screen buttons directly in the HOME - main menu. The desired heat
output (PLUS / MINUS buttons) is also set here.
The heating time program regulates the change between STANDBY-status and
CONTROL MODE automatically.
Tip
If no heating times are stored the icon „heating times" flashes and the stove
remains in standby.
The pellet burner start is within the heating times.
The pellet burner stop is outside the heating times.
In the operating status STOVE OFF no automatic pellet burner start is possible,
the system is turned off.
COMFORT MODE
The change from the operating status "STOVE OFF" to STANDBY-status (ON
button) and from STANDBY-status to STOVE OFF (OFF button) is made by
pressing the screen buttons directly in the HOME - main menu. The desired
room temperature (PLUS / MINUS buttons) is also set here.
In the COMFORT mode heating times can be activated additionally.
The pellet burner start is within the heating times (or always with heating
times deactivated) if the actual room temperature is below the desired room
temperature. In between the heating times the pellet burner starts if the actual
room temperature is below the decreasing temperature preset or if the frost
protection is activated.
The pellet burner stops either outside the heating periods, or if the actual room
temperature is higher than the desired room temperature.
In the operating status STOVE OFF no automatic pellet burner start is possible,
the system is turned off.
is
in
the
range
between
Log Operation
Note
Do not use inflammable liquids to heat up the fire!
Note
Your stove cannot overheat if operated correctly. However incorrect operation
may shorten the service life of the electrical components (blower, motors and
control system) and is therefore not permitted!
CORRECT HEATING UP
Open the combustion chamber door. The fan starts automatically as soon as
you open the door. Sweep the ashes into the bottom opening. After closing the
door the grid automatically starts to tip the ashes.
Place left and right 2 small pieces of chipboard longitudinally on the combustion
chamber floor.
Place 2-3 logs crossways to this chipboard.
Now place further chipboard pieces crossways and place 2-4 ribs of the RIKA-
firelighter on top of the chipboard. (If necessary some uncoated paper can be
placed under the chipboard instead of the firelighter.)
Now set the firelighter alight (or the uncoated paper) and close the combustion
chamber door.
Correct heating up counteracts above all excessive smoke during heating up.
Amount filled for heating up ~ 2kg
Amount added up to 1.3 - 2.6kg
Tip
You can order the RIKA firelighter with the number E15718 at your RIKA dealer.
|23
22
Advertisement
Table of Contents
