Removing And Installing Can Separating Connector (Left-Side) T46A - Audi 2003 A8 Workshop Manual

– Pull off retaining strip for connectors -arrows- and take con‐
nectors out of fuse holder.
– Unclip socket -1-.
Note
Exact assignment of contacts in fuse holder in dash panel (left-
side) can be found in applicable current flow diagram ⇒ Current
flow diagrams, Electrical fault finding and Fitting locations.
Installing
Installation is carried out in the reverse order; note the following:
Note
Refit all cable ties at the same locations when reinstalling.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– Install driver's storage compartment ⇒ Rep. gr. 68 .
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Connect battery. Steps required
Tightening torque
Component
Fuse holder to central tube for dash panel
4.2 Removing and installing CAN separat‐
ing connector (left-side) -T46a-
Removing
– Switch off ignition and take out ignition key.
– Use screwdriver to pry off trim (left-side) at dash panel
-arrow-.
– Press retaining tabs -1- at multi-pin connector.
– Release retaining clip -arrow- and unplug connector.
Note
The exact contact assignment of the CAN separating connector
(left-side) can be found in the appropriate current flow diagram
⇒ Current flow diagrams, Electrical fault finding and Fitting loca‐
tions.
Installing
Install in reverse order.
⇒ page 3 .
Nm
3
Audi A8 2003 ➤
Electrical system - Edition 08.2014
4. Relay carriers, fuse carriers (vehicle interior)
339