Removing And Installing Front Parking Aid Senders - Vehicles With Single-Frame Radiator; Grille; Removing And Installing Rear Parking Aid Senders - Audi 2003 A8 Workshop Manual

Audi A8 2003 ➤
Electrical system - Edition 08.2014
24.7 Removing and installing front parking
aid senders - vehicles with single-frame
radiator grille
Removing
– Remove bumper cover ⇒ Rep. gr. 63 .
Inner senders:
– Unplug electrical connectors -2- and -4-.
– Unscrew bolts -arrows-.
– Detach single-frame radiator grille -3- from bumper.
– Press parking aid senders -1- and -5- out of single-frame ra‐
diator grille.
Outer senders:
– Unplug electrical connector -1- at sender.
– Push both retainer tabs aside -arrows- and push out sender
inwards.
Installing
Installation is carried out in the reverse order; note the following:
Inner senders:
– Install bumper cover ⇒ Rep. gr. 63 .
Tightening torque
Component
Single-frame radiator grille to bumper
24.8 Removing and installing rear parking aid
senders
♦ Fitting location: in bumper cover -arrows-.
Note
Shown with bumper cover removed for illustration purposes.
♦
Senders can be taken out without removing rear bumper cov‐
♦
er.
Removing
– Switch off ignition and take out ignition key.
– Unscrew bolts -arrows-.
– Reach behind the bumper cover.
260
Rep. gr.94 - Lights, bulbs, switches - exterior
Nm
2.3
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.