Entry And Start Authorisation Switch E415; Removing And Installing Entry And Start Authorisation Switch E415 - Audi 2003 A8 Workshop Manual

23 Entry and start authorisation switch -
E415-
Note
Reader coil for immobiliser is attached to entry and start au‐
♦
thorisation switch - E415- and cannot be renewed separately.
The entry and start authorisation switch - E415- must be re‐
♦
newed if reading coil is defective.
23.1 Removing and installing entry and start
authorisation switch - E415-
Note
Adaption to immobiliser is not necessary if the entry and start
♦
authorisation switch - E415- is renewed.
The lock in the entry and start authorisation switch - E415- is
♦
not mechanically coded.
Therefore the keys must not be renewed after renewing entry
♦
and start authorisation switch -E415- (continue to use old
keys).
Special tools and workshop equipment required
♦ Socket tool - T10152-
Removing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Switch off ignition and take out ignition key.
with respect to the correctness of information in this document. Copyright by AUDI AG.
WARNING
When working on knee airbag, observe safety precautions for
working on airbags ⇒ Rep. gr. 69 .
– Remove driver's storage compartment ⇒ Rep. gr. 68 .
– Use small screwdriver to prise off trim ring at entry and start
authorisation switch -arrow-.
Audi A8 2003 ➤
Electrical system - Edition 08.2014

23. Entry and start authorisation switch E415

253