Inner Tail Light Cluster - Vehicles Up To 08.2007; Inner Tail Light Cluster - Exploded View; Removing And Installing Inner Tail Light Cluster - Audi 2003 A8 Workshop Manual

Audi A8 2003 ➤
Electrical system - Edition 08.2014
17 Inner tail light cluster - vehicles up to
08.2007
Observe notes on contact corrosion
17.1

Inner tail light cluster - exploded view

1 - LED printed circuit boards
❑ With tail light control unit
for lights on left - J692-
or tail light control unit
for lights on right - J693-
in rear lid
❑ Removing and installing
⇒ page 232
2 - 1 Nm
3 - Reversing light bulb
❑ 12 V, 16 W
4 - Housing cover
❑ For inner tail light cluster
5 - 1 Nm
6 - Bulb for rear fog light
❑ 12 V, 16 W
7 - 1 Nm
8 - 3 Nm
9 - Adjuster nut
❑ With sealing washer
❑ For aligning tail light
cluster with body con‐
tour
10 - Tail light
❑ Removing and installing
⇒ page 230
❑ Aligning with body con‐
tour ⇒ page 232
17.2 Removing and installing inner tail light
cluster
Removing
– Switch off ignition and take out ignition key.
– Turn light switch to position "0".
– Remove rear lid trim ⇒ Rep. gr. 70 .
230
Rep. gr.94 - Lights, bulbs, switches - exterior
⇒ page 125 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.