Cleaning The Hot Water/Steam Connection Nozzle; Cleaning The Hot Chocolate Carafe (E); Descaling - DèLonghi ECAM 650.75 Instruction Manual

43
5. Rinse inside the froth adjustment dial seat with running
water (fig. 44);
6. Check that the intake tube and spout are not clogged with
milk residues;
7. Replace the dial (in correspondence to the word "INSERT"),
spout and milk intake tube;
8. Place the lid back on the milk container (D3).
16.11 Cleaning the hot water/steam connection
nozzle
Each time you prepare milk, clean the connection nozzle (A9)
with a sponge to remove milk residues from the gaskets (fig.
22).

16.12 Cleaning the hot chocolate carafe (E)

Clean the carafe each time you make hot chocolate as described
below:
1. Lift the lid (E1) and remove the funnel (E2) by pressing
the release button (E6) and lifting (fig. 23);
2. Extract the steam spout (D3) and stirrer (D4);
3. Wash all the components thoroughly with hot water and
mild washing-up liquid.
All components are dishwasher safe, placing them
in the top basket of the dishwasher.
4. Replace all the components in the appliance.
Please note!
It is normal to find residues on the stirrer while cleaning. These
consist of traces of iron in the cocoa attracted by the magnets
in the stirrer.
17.

DESCALING

Important!
• Before use, read the instructions and the labelling on the
descaler pack.
• You should use De'Longhi descaler only. Using unsuitable
descaler and/or performing descaling incorrectly may re-
sult in faults not covered by the manufacturer's guarantee.
Descale the appliance when "DESCALING NEEDED PRESS OK TO
START (~40min)
the appliance immediately, press "
structions from point 4.
To descale the appliance later, press "
appears on the display to remind you that the appliance needs
descaling.
44
To access the descaling menu:
1. Press "
2. Press < (B10) or > (B8) until " DESCALING" appears on
the display;
3. Press "
structions on the display;
A
21
": appears on the display (B). To descale
OK" and follow the in-
ESC". The
" (B2) to enter the menu;
" to start the descaling cycle then follow the in-
4. "REMOVE WATER SOF-
TENER FILTER" (fig. 45):
extract the water tank
(A16), remove the water
softener filter (C4) (if
present) and empty the
water tank. Press "
NEXT";
45 5 5 5 5 5 45 45
5. "ADD DE'LONGHI DESCAL-
ER (LEVEL A) AND WATER
(UP TO LEVEL B)" (fig. 46);
+
B
Pour the descaler into the
tank up to the level A
marked inside the tank
(equal to one 100 ml
B
pack), then add water
A
(one litre) up to level B
and put the water tank
back. Press "
46 6 6 46
6. "EMPTY DRIP TRAY" (fig.
47): Remove, empty
and replace the drip tray
(A14) and grounds con-
tainer (A10). Press "
NEXT";
47
symbol
NEXT";