Table of Contents
Advertisement
9. Close the infuser door.
10. Replace the water tank.
cleaning the milk container
Clean the milk container each time you prepare milk as de-
scribed below:
1. Remove the lid.
2. Remove the milk
spout and intake
tube.
3. Turn the froth
adjustment dial
clockwise to the
"INSERT" position
(see figure) and
pull off upwards.
4. Wash all the
c o m p o n e n t s
thoroughly with
hot water and
mild washing-up
liquid. All components are
dishwasher safe, placing them
in the top basket of the dish-
washer.
Make sure there are no milk
residues on the hollow and
groove under the dial (see
figure alongside). If necessary,
scrape the groove with a tooth-
pick.
5. Rinse inside the froth adjust-
ment dial seat with running
water (see figure).
6. Check that the intake tube and
spout are not clogged with milk
residues.
7. Replace the dial (lining up the
arrow with the word "INSERT"), the spout and the milk
intake tube.
8. Place the lid back on the milk container.
cleaning the hot water/steam nozzle
Each time you prepare milk, clean the nozzle with a sponge to
remove milk residues from the gaskets.
DEscALinG
Descale the machine when the message "DESCALE" and the
symbol " " flashe on the display.
Important!
•
Descaler contains acids which may irritate the skin and
eyes. It is vital to follow the manufacturer's safety warn-
ings given on the descaler pack and the warnings relating
to the procedure to follow in the event of contact with the
skin and eyes.
•
Use De'Longhi descaler only. Under no circumstances
should you use sulphamic or acetic based descalers. Their
use invalidates the guarantee. Failure to descale the appli-
ance as described above also invalidates the guarantee.
1. Turn the machine on.
2. Press the MEnu/Esc button to enter the menu.
3. Press < or > until "Descale" is displayed.
4. Select by pressing the
played. Press the
5. "DESCALE", "EMPTY DRIP TRAY" is displayed, alternating
with "Remove filter" (if the filter is present) and "ADD DES-
CALER PRESS OK".
6. Empty the water tank (A9) completely and remove the
water softener filter (if present). Empty the drip tray (fig.
29) and grounds container, then put them back in the ap-
pliance.
7. Pour the descaler
into the tank up
to level A (corre-
sponding to a 100
ml pack) marked
on the back of the
tank (fig. 36), then
add water (1 litre)
up to level B (fig.
36) and put the
water tank back.
8. Place an empty container with a minimum capacity of 1.5
litres under the hot water spout (fig. 7).
Important! Danger of burns
Hot water containing acid flows out of the hot water spout.
Avoid contact with splashes of water.
9. Press the
the solution. The descale programme automatically per-
forms a series of rinses and pauses to remove limescale
deposits from inside the machine.
17
button: "Confirm?" is dis-
button to confirm.
button to confirm that you have added
B
A
Advertisement
Table of Contents
Troubleshooting
