Handset Charger Installation - AT&T 2462 User Manual

2462_00_1 ATT CIB 1/28

Handset Charger Installation

1 Connect the power cord. Feed the
power cord through the strain-relief
channel on the bottom of the handset
charger. Then plug the cord into an
electrical outlet not controlled by a
wall switch.
2 Install the handset battery.
Use only the battery supplied with this handset or AT&T
Accessory Battery Model 2401, SKU# 91077.
b) Place the battery pack in
the handset. Match the
metal contacts on the
battery with the contacts
in the battery
compartment.
1/28/02 9:52 AM
CHARGING Light: on when
handset is in charging stand
a) Remove
battery
compartment
cover by
pressing on
indentation
and sliding
downward.
Page 5
INSTALLATION
c) Replace cover
by sliding it on
its track up
over battery
case until it
snaps firmly
into place.
5