Control settings, heating circuits
Standard room temperature
Parameter
2000 - HK A1
3000 - HK M2
4000 - HK M3
Reduced room temperature
Parameter
2001 - HK A1
3001 - HK M2
4001 - HK M3
Heating circuit switching times
Parameter
2002 - HK A1
3002 - HK M2
4002 - HK M3
Activating the remote control
Parameter
2003 - HK A1
3003 - HK M2
4003 - HK M3
The Vitotrol 200 can be installed for
every heating circuit. It must be allo-
cated to the respective heating circuit.
Note
Remote control units have no function
when the heat pump is in manual
mode "h" (see page 113).
158
Separate setting of switching times for
all heating circuits A1, M2 and M3.
Operating instructions
Separate setting of switching times for
all heating circuits A1, M2 and M3.
Operating instructions
Separate setting of switching times for
all heating circuits A1, M2 and M3.
Operating instructions
Access
Device settings
Programming
Heating circuit 1
y until "Remote control" is high-
lighted
"YES" or "NO"
also applies to heating circuit 2 and
heating circuit 3
Standard setting
Setting range
Vitotrol 200 installation instruc-
tions
No
Yes/No