Table of Contents
Advertisement
Explorer 107 Operation and Maintenance Manual
5.3.1 Power
a) Clear the area around the laminating rollers
and pull rollers.
b) Ensure that the laminator is plugged in and
no E-STOP is depressed.
c) Press POWER to the "I " position to turn on
the laminator.
!
R O L L L A M I N A O R
Model
Explo er 1
nput o tage
22
/ 6 Hz
nput cu rent
2 A
ower cun upt on
5 8
W
empe atu e ange
Up
C
6
Cu rent at ng of ir uit b eaker
3 A
Max lam nat ng w dth
1
5 mm
Se ial No
### ###### ##
Made in Korea /
ab ique En Co ee
d) Press POWER to "O" position to turn off the
laminator.
© GBC Pro - Tech December 1999
5.3.2 Film loading
or Poly-Out films. Each film requires a different loading
procedure. Refer to Section 6 Applications for
webbing methods. With regards to webbing methods,
both require the adhesive side of the film to face away
from the heating components.
Extreme caution should always be exercised
a) Lift the upper unwind shaft from the lateral
Power
Lateral film adjustment
The Explorer 107 can accommodate Poly-In
WARNING
when removing an unwind shaft, the
gripper tabs can cut you!
film adjustment side out of its support
saddle.
Operations
Page 5 - 11
Advertisement
Table of Contents
