Operation; Select System Mode (Em Heat/Heat/Off/Cool/Auto); Change Temperature Set Point - Aprilaire Home Comfort Control 8830 Owner's Manual

WI-FI SETUP
STEP 3
Configure the Home Comfort Control to connect
to the Wi-Fi network.
Open a web browser on your computer or mobile
device . In the browser enter:
http://192 .168 .1 .99/index .html
In the web browser interface select the network you
want to connect the Home Comfort Control to, and
enter the network's security credentials .
8
STEP 4
Verify the Home Comfort Control is connected
to the Wi-Fi network.
Once all the required information is entered in the
web browser interface, the Home Comfort Control
will connect to the Wi-Fi network you selected . After
the Home Comfort Control is connected to the Wi-Fi
network, the Home Comfort Control will display the
radio bars based on the Wi-Fi signal strength . If the
radio bars are not displaying the signal strength, refer
to Troubleshooting Wi-Fi Connection on pages 34-35 .
Note: If you are not using the Home Comfort Control
with a home automation system, but are instead using
an Aprilaire account to communicate with the Home
Comfort Control, refer to Wi-Fi Thermostat App User
Guide and then Start Up on my.aprilaire.com for
instructions on connecting to Wi-Fi and registering
to an Aprilaire account . For additional instructions on
using the Aprilaire web and mobile Apps refer to Wi-Fi
Thermostat App User Guide on my.aprilaire.com .

OPERATION

SELECT SYSTEM MODE
(EM HEAT/HEAT/OFF/COOL/AUTO)
Press [MODE] to select:
EM HEAT: (only for heat pumps with auxiliary heat) Home
Comfort Control controls auxiliary heat . Heat pump will not
operate in EM HEAT mode .
HEAT: Home Comfort Control controls only the heating system .
OFF: Heating and cooling systems are off .
COOL: Home Comfort Control controls only the cooling system .
AUTO: (if enabled in installer setup) Home Comfort Control
automatically selects heating or cooling depending on the
indoor temperature .
Press [DONE] to save and exit, or [CANCEL] to exit without
saving . The Home Comfort Control will save and exit if nothing
is pressed within 10 seconds .

CHANGE TEMPERATURE SET POINT

Press
or to adjust the current set point .
(See Program Schedule Holds on pages 28-32 for
more information .)
9