Aprilaire Home Comfort Control 8830 Owner's Manual page 20

SETUP MENU
USER SYSTEM SETTINGS TABLE
(CONTINUED)
User system
setting Description
Setpoint Lockout Prevents or limits changes to the heating and cooling setpoints
at the Home Comfort Control . If set to Full, no changes to the
setpoints are allowed . If set to Range, changes to the setpoint
are limited by the Max Temp Setpoint Change in Lockout . If set
to Time and Range, changes to the setpoint are limited by the
Max Temp Setpoint Change in Lockout and the changes will last
for the duration set by Setpoint Change Time Limit in Lockout .
Note: Only available when the Lockout Type is set to Partial .
Max Setpoint Sets the maximum change to the heat or cool setpoint that can
Change in Lockout be made at the Home Comfort Control . Note: Only available
when Setpoint Lockout is set to Range or Time and Range .
Setpoint Change Sets the duration that changes to the setpoint that are made at
Time Limit in the Home Comfort Control will last before reverting back to the
Lockout original setpoint . Note: Only available when the Home Comfort
Control is configured to work with home automation and
Setpoint Lockout is set to Time and Range .
38
SETUP MENU
USER SYSTEM SETTINGS TABLE
Factory default setting User system
(bold) and setting range setting
Disable Menu Lockout
Range
Time and Range
Full
Program Format
Reset Service
Reminders
3°F or 1.5°C
1°F to 20°F (0 .5° to 10°C)
Backlight
60 Minutes
Intensity
15 to 480 Minutes
WiFi Disconnect
and Clear Settings
(CONTINUED)
Description
Prevent the Menu screen from being accessed at the Home
Comfort Control . Note: Only available if no other lockouts
are enabled . If another lockout is enabled the Menu screen is
automatically locked out .
Enables the 7 day program .
Clears the Change Air Filter, Fresh Air, Dehumidifier, and HVAC
service reminders if they are active and resets the start date to
the current date . Clears the Change Water Panel reminder if it is
active . If the reminder is set to timed, the timer will be reset .
Set the active backlight intensity . Note: The minimum setting is
40% when Constant Backlight is enabled .
Disconnects the Home Comfort Control from the router and
clears the Wi-Fi settings . Use this to set the Home Comfort
Control back to provisioning mode so it can be connected to a
new Wi-Fi router .
Factory default setting
(bold) and setting range
Disable
Enable
7-Day
Non-Prog
No
Yes
100 Percent
0 to 100 Percent
No
Yes
39