Denon DRA-100 Owner's Manual page 82

Contents Connections
Network
To use this unit by connecting it to a home network (LAN), you must configure network settings. If you set up your home network via DHCP, set "DHCP" to
On (use the default setting). This allows this unit to use your home network.
If you assign an IP address for each device, you must use the "IP Address" setting to assign an IP address to this unit and enter the information about your
home network such as the gateway address and subnet mask.
Network Information
Display network information.
Friendly Name / DHCP On or Off / IP Address / MAC Address /
SSID
z
z This is displayed only while a Wi-Fi connection is enabled.
Front panel Rear panel
Playback Settings
Network Control
Enables network communication in standby power mode.
On:
Off
(Default):
0 When using the Web control function or a network controller or when you want to
use Bluetooth/NFC quickly when the power is off, set "Network Control" to "On".
NOTE
0 When "Network Control" is set to "On", the unit consumes more standby power.
Remote control 82
unit
Tips
The network function can be used when in
standby power mode. Main unit operable
with a network compatible controller.
The network function cannot be used in
standby power mode.
Index
Appendix