Fx Edge Iii/Fx Edge Iii-8 Bridge - Ibanez Prestige Series User Manual

FX Edge III/FX Edge III-8 bridge

■
FX Edge III
1
6
5
Adjusting the action
1.
To adjust the string height, use a slotted screwdriver to
turn the main studs at the left and right of the bridge unit to
adjust the height of the entire tremolo unit. (It is not possible
to adjust the height of individual strings.)
2.
Use an Allen wrench (3 mm) to turn the rear studs, adjusting
them so that the bridge is approximately parallel with the
surface of the guitar body.
※
As the action will change when you adjust the rear studs, it is recommended that you check the fi nal action
after you've adjusted the rear studs.
To prevent the screw holes from being damaged, loosen the strings suffi ciently before you adjust the main
studs so that you will not have to use excessive force when turning the studs.
Adjusting the intonation
1.
Use an Allen wrench (3 mm) to loosen the pressure
pad bolts of the locking nut, and loosen the strings
suffi ciently.
2.
Use an Allen wrench (2 mm) to loosen the saddle
lock bolt, and adjust the saddle position.
※ Before checking the intonation, fi rmly tighten the saddle lock
bolts and tune the guitar correctly. When you've fi nished
making adjustments, tighten the saddle lock bolts and the
pressure pad bolts of the locking nut.
2
3
1
4
1Main stud
2Saddle lock bolt
3String holder block
4String stopper bolt
5Rear stud
6Fine tuning bolt
EN
55
➤➤