Attachments; String Replacement - Ibanez Prestige Series User Manual

ATTACHMENTS

Edge tremolo bridge
Edge-Pro tremolo bridge
Edge-Zero tremolo bridge
Lo-Pro Edge tremolo bridge
FX Edge III-8 bridge
SynchroniZR tremolo bridge
Gibraltar Standard 6/7/8 bridge
GIBRALTAR BRIDGE 08 / QUICK
CHANGE 08 TAILPIECE
TIGHT-TUNE BRIDGE
Tight-End / Tight-End R bridge
ZR-2 tremolo bridge
Semi-acoustic guitars
Full acoustic guitars
※
Models equipped with DiMarzio pickups are shipped with an Allen wrench for adjusting the height of the
pole pieces.
※
Reinforcement springs are included with models equipped with the 7-string Edge-Zero tremolo bridge.

STRING REPLACEMENT

Strings will deteriorate over time, causing buzzing or inaccurate pitch. Replace the strings whenever
your strings begin to rust or become discolored. We recommend that you replace all of the strings as a
set at the same time. Bent, twisted, or damaged strings will not produce the appropriate quality sound
and therefore should not be used.
Wind the string around the tuning machine post two or three
times from above, using about 5--7 cm of length and taking
care that the string does not cross itself. The strings should be
replaced one by one instead of removing all the strings at once.
This is done to avoid stress on the neck and to reduce the risk
of affecting tremolo balance.
※
When using a model with AUTO-TRIM pegs, the strings must be wound in a different way. For details, refer
to the section "AUTO-TRIM peg" (p. 42).
※
The method for removing and installing strings attached to a tremolo/bridge will differ depending on the type
For details, refer to the section for the tremolo/bridge installed on your guitar.
of tremolo/bridge.
38
Multi- Tremolo
tool arm
1.5mm
 
 
 
 

 




 

Allen wrench
2mm 2.5mm 3mm
8mm
socket
4mm
wrench




 
