Adjusting The Action; Adjusting The Intonation - Ibanez Prestige Series User Manual

Memo
• Loosen the strings suffi ciently before you install or remove tremolo springs. Be aware that if you
remove all of the springs, the tremolo unit will detach from the guitar.
• To reattach the tremolo, insert the knife edge of the tremolo securely into the groove of the stud bolts,
and then install the tremolo springs.
Stud lock
The Edge/Lo-Pro Edge tremolo bridge uses a stud lock
mechanism.
1.
Insert an Allen wrench (1.5 mm) through the hole in the
top of the stud bolt.
2.
Turn the stud lock bolt clockwise, tightening it until it
contacts the anchor nut and can no longer rotate.
※ The stud lock will be released when you loosen the stud lock bolt.

Adjusting the action

To adjust the height of the entire tremolo unit, use an Allen wrench
(4mm) to turn the stud bolts located at the left and right of the
tremolo unit. (It is not possible to make adjustments for each string
individually.)
Memo
• Make sure that the stud lock is released before you adjust the
action.

Adjusting the intonation

1.
Use an Allen wrench (3 mm) to loosen the pressure
pad bolts of the locking nut, and loosen the strings
suffi ciently.
2.
Use an Allen wrench (2 mm) to loosen the saddle
lock bolts, and adjust the saddle position.
※ Before checking the intonation, fi rmly tighten the saddle lock
bolts and tune the guitar correctly. When you've fi nished
making adjustments, tighten the saddle lock bolts and the
pressure pad bolts of the locking nut.
EN
45
➤➤