Staple & Group; Ps_Eps File Output - Canon DU7-1178-000 Service Manual

2.1.9 Staple & Group
You can use it to enable the selection of stapling when printing in Group mode. Staple & Group permits
stapling of pages in sets.
F-2-13
If 'Store' is selected as 'Output Method' on the Finishing tab, [Staple & Group] will be grayed out, not per-
mitting selection.
If 'Store' is selected as 'Output Method' while selecting [Staple & Group], a switchover will take place for
[Finishing] so that [Staple & Group] will be [Collate].

2.1.10 PS_EPS file Output

PS Printer Driver Only
Support of EPS (Encapsulated PostScript)
When printing an EPS file existing in an application program, selection of PS_EPS File Output will enable
printing of the EPS data as it is without conversion into PS print data.
In EPS, page size is not described in the file so that the page range is determined with reference to the im-
age size.
The paper size will be fixed to the default paper size specified as part of print settings on the iR engine
control panel.
_If the image is smaller than the paper size, centering will take place.
_If the image is larger than the paper size, on the other hand, the upper left corner of the paper and that of
the page will be matched.
F-2-14
Reference
EPS data contains PostScript data created using graphics application software (e.g., Adobe Illustrator) and
preview data for display in DTP software being used. When an EPS file is selected as the output mode,
some applications prevent printing of the preview data.
Chapter 2
0011-3465
0011-3466
2-9