Canon DU7-1178-000 Service Manual page 90

Message Error code Cause
No response #751
TCP/IP error #755
Check server #801
Cannot find server #802
Check address #804
Check address. #806
No messag #807
Remedy
- Server has not booted - Check transmission destination and network settings.
up. - Transmission jobs whose processing has stopped for
- Network disconnected. some reason or other are forced to quit by assigning an
(If connection cannot be internal error code (#751). As a result, after rebooting,
made with transmission the job is not run.
destination, connection
is sometimes cut mid-
way.)
- Reset caused by
internal error.
Processing interrupted.
- IP address set to
- Set the IP address correctly or set DHCP, RARP,
0.0.0.0. In the following BOOTP environments to operate properly.
two situations, the IP - Turn power OFF/ON.
address is 0.0.0.0.
1) Address could not be
obtained from DHCP,
BOOTP, RARP.
2) Unit launched in IP
fixed mode(keys 1+7 to
enter FIXIPmode).
- TCP/IP protocol stack
resources insufficient.
Even with internal retry
(5 times),transmission
failed.
- Error generated due to - Reset server.
cause on server side. - Check server status and settings.
- SMB server side file - Check the network traffic.
capacity not sufficient.
- In WindowsNT/2000
server, password was
incorrect.
- In WindowsNT SMB,
common file name did
not match.
- In SMB, a user exists
but no write privileges.
- SMB transmission
made to write-
prohibited file of the
same name.
DNS/SMTP setting Reprogramme the user mode settings. (domain name, E-
error(DNS error) Mail address, DNS, mail server)
- No match for specified - Check that the destination directory name is correct.
directory name. - Set directory access privileges in the server.
- In SMB, a user exists
but no write privileges.
- Wrongly specified user - Change address book user name or password.
name.
- Wrongly specified
password. (Excl.
Windows NT.)
No access rights for the - Check the access rights to the server.
specified directory
Chapter 4
4-13