Set/Change The Desired Speed; Set The Clearance Level - Skoda Octavia Owner's Manual

Resume control
›
Start control » page 152.
WARNING
Control may only be resumed if the stored speed is not too high for the cur-
rent traffic conditions.
Note
Regulation is also stopped when the clutch is held down for longer than 30 s.

Set/change the desired speed


Read and observe on page 150 first.
The desired speed can be set or changed using the control lever
page 152.
The set speed is stored upon releasing the lever or the button on the button
on the lever.
Setting/changing the speed by 10 km/h at a time () - requirements
ACC is enabled.

Increasing the speed by 1 km/h at a time () - requirements
ACC is enabled.

Vehicle control is taking place.

Decreasing the speed by 1 km/h at a time () - requirements
ACC is enabled.

Vehicle control is taking place.

Changing the speed by adopting the current speed () - requirements
ACC is enabled.

The vehicle is moving at a speed other than that which is stored.

Note
If during control the speed is increased by pressing the accelerator, control is
■
temporarily stopped. Upon releasing the accelerator, control is automatically
resumed.
If during control the speed is reduced by applying the brake, control is stop-
■
ped. Control needs to be restarted in order to resume
If the vehicle is controlled by a lower speed than the stored speed, then 
■
the current speed is stored the first time the key is pressed. Press the key
again  and the speed is reduced in increments of 1 km/h.

Set the clearance level


Read and observe
» Fig. 171 on The proximity to the vehicle ahead can be set with the lever
page 152 or in the Infotainment
vehicle settings.
Setting by means of the lever
›
Set the switch  Adjust in the spring-tensioned position
» Fig. 171 on page 152.
The display of the instrument cluster shows line
which indicates the proximity.
›
Using the switch  Adjust the line
the lever.
Note
If the proximity is changed in infotainment, the change will only come into
■
effect after a subsequent activation of the ACC.
The proximity is dependent on the speed. The higher the speed, the greater
■
the proximity to the vehicle ahead.
On wet roads, a longer time interval to the vehicle ahead should always be
■
selected than on dry roads.
» page
on page 150 first.
» Owner´s Manual Infotainment, chapter CAR -
» Fig. 169
2
to the desired distance level on
2
Assist systems
152.
» Fig. 171 on
or
-

on page 150,
153