Closing
›
Pull gently on the top edge of the corresponding button and hold until the
window has moved into the desired position.
Releasing the button causes the window to halt immediately.
The window can also be fully closed automatically by pulling the button up to
the stop. Renewed pulling of the button causes the window to stop immedi-
ately.
Disable/enable the buttons in the rear doors
›
Press button
» Fig.
48.
E
When the buttons in the rear doors are disabled, the warning light
illuminates.
E
After switching the ignition off, it is still possible to open or close the windows
for approx. 10 minutes.
After the driver's or passenger's door is opened the operation of the window is
only possible with the button
A
ed or pulled for approx. 2 seconds.
The window lift mechanism is equipped with protection against overheating.
Repeated opening and closing of the window can cause this mechanism to
overheat. If this happens, it will not be possible to operate the window for a
short time. You will be able to operate the window again as soon as the over-
heating protection has cooled down.
WARNING
The system is fitted with a force limiter
■
cle, the closing process is stopped and the window goes down by several
centimetres. The windows should nevertheless be closed carefully – risk of
injury!
If the rear seats are accommodating people who are not completely inde-
■
pendent, e.g. children, it is recommended that the buttons in the rear doors
be disabled with button
for safety reasons.
E
CAUTION
In the winter, ice accumulating on the surface of the window may cause
■
there to be more resistance when closing the window. The window will stop
and move back several centimetres.
Keep the windows clean to ensure the correct functionality of the electric
■
windows.
Always close the windows before disconnecting the battery.
■
» Fig.
48, in which case they have to be press-
» page
63. If there is an obsta-
Opening/closing the windows in the front passenger door and in
the rear doors
in button
Read and observe
There is a button in the front passenger door and in the rear doors for that
window.
Opening
›
Lightly press the button downwards and hold it until the window has moved
into the desired position.
Releasing the button causes the window to halt immediately.
The window can be completely opened automatically by briefly pressing the
down button as far as the stop. Renewed pressing of the button causes the
window to stop.
Closing
›
Lightly press the button upwards and hold it until the window has moved in-
to the desired position.
Releasing the button causes the window to halt immediately.
The window can be completely closed automatically by briefly pressing the up
button as far as the stop. Releasing the button causes the window to halt im-
mediately.
Force limit
Read and observe
The electrical power window system is fitted with a force limiter.
If there is an obstacle, the closing process is stopped and the window goes
down by several centimetres.
Fig. 49
Power window button
and
on page 62 first.
and
on page 62 first.
Unlocking and opening
63