High-Beam Assistant (Light Assist) - Skoda Octavia Owner's Manual

Hide thumbs Also See for SKODA Octavia:
Table of Contents

Advertisement

Dynamic cornering lights
The cone of light in front of the vehicle is adjusted to the steering angle so
that the road in the curve is illuminated. This function is active at speeds
greater than 10 km/h and in all system modes.
travel mode
If the travel mode is activated, there is no automatic cone of light adaptation
in front of the vehicle.
The travel mode can be activated/deactivated in the Infotainment
Manual Infotainment, chapter CAR - vehicle settings.
Economy mode
When the Eco driving mode
» page 157
mode and there is no direction dependent light cone adaptation in front of the
vehicle.
WARNING
If there is a system malfunction the headlights are automatically lowered
to the emergency position, which prevents a possible dazzling of oncoming
traffic. This reduces the cone of light in front of the vehicle. Drive carefully
and visit a specialist garage as soon as possible.

High-beam assistant (Light Assist)

1)
Only valid for some countries.
»
Owner´s
is activated the system is in Economy
Fig. 57
Camera view window for the
main beam assistant
Read and observe
on page 67 first.
The main beam assistant (hereinafter referred to as system) can prevent other
road users from being dazzled.
The system automatically switches the high beam on/off in accordance with
the existing traffic (other vehicles) and environmental conditions (e.g. driving
through a lighted village).
The high beam on/off is controlled by a sensor or a camera
The system works under the following conditions.
The light switch is in the position .
The system is activated.
The system is switched on.
The vehicle speed is above 60 km/h or above 40 km/h
The headlight switches off automatically when the speed falls below 30 km/h.
Activation/deactivation
The activation/deactivation can also be displayed in the Infotainment
´s Manual Infotainment, chapter CAR - vehicle settings.
Switching on
Place the lever in position
(spring-tensioned position)
A
The instrument cluster illuminates the warning light  of the systems switch-
ed on.
Switching off
If the headlight is switched on automatically, move the lever into position
(spring-tensioned position)
» Fig.
Fig. 58
Operating lever: High beam as-
sistant activation/deactivation
» Fig.
57.
.
1)
» Fig.
58.
58.
Lights and visibility
»
Owner
B
71

Advertisement

Table of Contents
loading

Table of Contents