To Programme The Water Hardness Level - Miele G 2XXX Series Operating Instructions Manual

Before using for the first time
To programme the water hardness
level
Each time a button is pressed, one of
the indicator lights will flash and light
up in the control panel. However, only
the indicator lights mentioned in the
following programming process stages
are significant.
The programming procedure can be
cancelled at any time by pressing the
K button. The procedure can then be
re-started from the beginning again.
^ Switch the dishwasher off using the
K button.
^ Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the K button.
Keep the Start/Stop button pressed in
until the Start/Stop indicator comes
on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Delay start button twice.
The lowest programme indicator
flashes twice briefly at intervals, and the
Wash/Rinse programme sequence
indicator flashes 4 times briefly at
intervals (factory default setting).
16
The number of times the Wash/Rinse
programme sequence indicator flashes
tells you the value which has been set
(see chart).
°d mmol/l
1 - 4 0.2 - 0.7
5 - 7 0,.9 - 1.3
8 - 11 1.4 - 2.0
12 - 15 2.2 - 2.7
16 - 20 2.9 - 3.6
21 - 25 3.8 - 4.5
26 - 30 4.7 - 5.4
31 - 36 5.6 - 6,.5
37 - 45 6.7 - 8.1
46 - 70 8.3 - 12.6
^ Use the Start/Stop button to select
the number of flashes which equates
to your water hardness level.
Each press of the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
Example:
If your water hardness level is
4.0 mmol/l (22 °d), the Wash/Rinse
indicator should flash briefly six times
at intervals.
^ Switch the dishwasher off using the
K button.
°f Wash/Rinse
indicator
flash
frequency
2- 7 Once briefly
9- 13 Twice briefly
14- 20 3 times briefly
22- 27 4 times briefly
29- 36 5 times briefly
38- 45 6 times briefly
47- 54 7 times briefly
56- 65 8 times briefly
67- 81 9 times briefly
83-126 Once for
longer