Insert Srmemory Card; Inserting And Removing The Srmemory Card; Supported Srmemory Cards - Sony SR-R1 Operation Manual

Insert SRMemory Card

Supported SRMemory cards

The SR-R1 can use the following types of
SRMemory cards.
For 59.94i
SRMemory card SR-Lite SR-SQ SR-HQ
SR-256S15/256S55 114
SR-512S25/512S55 229
SR-1TS25 458
For 50i
SRMemory card SR-Lite SR-SQ SR-HQ
SR-256S15/256S55 137
SR-512S25/512S55 274
SR-1TS25 550
For 23.98P
SRMemory card SR-Lite SR-SQ SR-HQ
SR-256S15/256S55 143
SR-512S25/512S55 286
SR-1TS25 573
1) Recording times will differ depending on equipment
and shooting conditions.
Inserting and Removing the
SRMemory Card
To insert the SRMemory card
1
Press the lid open/close button to open
the lid of the SRMemory card slot and
insert the SRMemory card.
Take care to insert the SRMemory card with
the correct orientation.
60 32
120 64
241 128
Unit: minutes (approx.)
72 38
145 76
290 153
Unit: minutes (approx.)
75 40
151 80
302 160
Unit: minutes (approx.)
Tips
• If the LID LOCK indicator is lit in orange,
showing that the lid is locked, press the EJECT
button on the control panel to unmount the card
first, and then open the lid.
• If power was turned off with the lid in the locked
state, turn power on again and then press the
EJECT button on the control panel to unmount
the card.
2
Push the SRMemory card all the way in
and close the lid.
The SRMemory card is mounted, and the
LID LOCK indicator lights up in orange.
Verify that no error message is shown on the
control panel display.
If "XXX: SALVAGE DETECT" is shown on the
display
This indicates that the previous recording did not
complete normally.
For information on what to do in this case, see
"Salvaging SRMemory cards for which recording
did not complete properly" (page 92) in the
"Troubleshooting" section.
Insert SRMemory Card
SRMemory card
23