Checking The Ignition System - PEUGEOT Ludix 4T Workshop Manual

ELECTRICITY

Checking the ignition system

- Remove the battery access door.
- Disconnect and remove the battery.
- Remove the battery bracket.
Disconnect the ignition unit and take the
measurements on the harness side.
- If the values are correct, replace the ignition
module.
- If the values are incorrect, check:
• The harness.
• The ignition switch.
• The ignition sensor.
• The high voltage coil.
Component
Ground
Ignition sensor
Battery positive power
HT coil:
Primary
Secondary
Spark plug socket
38
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
Connector Wire colours
A
To the ground
A
To the ground
B
To the ground
A Yellow/black and Green
High tension wire and Gren
B
A
Green
Yellow/blue
Black
Standard values
R=0Ω
R=115 Ω
±20%
Ignition on: U=12V
Ignition off: U=0V
R=0.2 Ω ±20%
±20%
R=3 KΩ
±20%
R=5 KΩ