The Initialization Operation - Toyota Avensis Owner's Manual

The initialization operation (vehicles with the tire pressure warning

system)
 Make sure to carry out initialization after adjusting the tire inflation pres-
sure.
Also, make sure the tires are cold before carrying out initialization or tire
inflation pressure adjustment.
 If you have accidentally turned the engine switch to the "LOCK" position
(vehicles without a smart entry & start system) or off (vehicles with a
smart entry & start system) during initialization, it is not necessary to
press the reset switch again as initialization will restart automatically
when the engine switch has been turned to the "ON" position (vehicles
without a smart entry & start system) or IGNITION ON mode (vehicles
with a smart entry & start system) for the next time.
 If you accidentally press the reset switch when initialization is not neces-
sary, adjust the tire inflation pressure to the specified level when the tires
are cold, and conduct initialization again.
 Warning performance of the tire pressure warning system (if equipped)
The warning of the tire pressure warning system will change in accordance
with the conditions under which it was initialized. For this reason, the system
may give a warning even if the tire pressure does not reach a low enough
level, or if the pressure is higher than the pressure that was adjusted to
when the system was initialized.
 When initialization of the tire pressure warning system has failed (if
equipped)
Initialization can be completed in a few minutes. However, in the following
cases, the settings have not been recorded and the system will not operate
properly. If repeated attempts to record tire inflation pressure settings are
unsuccessful, have the vehicle inspected by any authorized Toyota dealer or
repairer, or another duly qualified and equipped professional.
 When operating the tire pressure warning reset switch, the tire pressure
warning light does not blink 3 times.
 After driving for a certain period of time since the initialization has been
completed, the warning light comes on after blinking for 1 minute.
AVENSIS_OM_OM20B99E_(EE)
4-3. Do-it-yourself maintenance
553
4