Assembly Procedures Tools Required; Parts Bag Contents; Unpack And Assembly Legs - Vermont Castings 3225 Installation And Operating Manual

WARNING
Failure to position the parts in accor-
dance with these diagrams or failure to
use only parts specifically approved for
use with this heater may result in property dam-
age or personal injury.
This heater and components are heavy. Have
help available for assembly.
Tools Required
• Phillips screwdriver (stub)
• utility knife
• metal drill bit: size 28 (.140"/3.5mm)

Parts Bag Contents:

•
Control door handle/screw
•
(3) Vent Screws
•
(2) Switch bracket screws
•
Ceramic handle w/insert lifter (handle for operable
door)
•
On-Off switch, housing, and wiring harness
(3) Phillips round-head bolts, 1/4"- 20 x 1/2"
•
(2) Bag of Lava Rocks
•
(1) Tube of Vent Gasket Cement
•
(1) Vent Restrictor Plate, 2¹⁄₄" inside diameter
•
Owner Registration Card
•
(4) CS, Hex Hd 3/8-16 x 1 Gr 2-Z
•
(4) Washer, Fl 3/8-Z
Unpack and Assemble Legs
The Radiance is shipped upright. Cut the shipping
straps and set stove upright.
1. Slide stove to the rear of the pallet just far enough to
access rear leg holes. Make sure the stove does not
tip over backwards. (Fig. 12)
2. Attach the rear legs using 3/8" hex head bolts and
flat washer supplied. Tighten with a 9/16" wrench or
socket.
3. Carefully tip the stove onto its rear legs. Adjust
the pallet to allow access to one of the front leg
holes. Be sure to leave the pallet under the stove
to prevent the stove from falling fully forward. (Fig.
13) CAUTION: To prevent valve tubing from being
crushed or damaged, make sure to rest valve on
wooden pallet.
20004188
Assembly Procedures
• power drill
• reciprocating saw
Radiance Direct Vent /Natural Vent Gas Heater
Fig. 12 Slide stove back just far enough to access rear leg
holes.
ST720
Radiance
slide stove back
7/30/02 djt
Fig. 13 Carefully tip stove onto back legs. Leave pallet under
stove to keep stove from falling fully forward.
4. Have your assistant attach one leg using the hard-
ware described.
5. Move the pallet to allow access to the other front leg
hole. Attach remaining leg.
6. Remove pallet and allow stove to gently rest on all
four legs.
7. Adjust leg levelers to compensate for irregularities in
the hearth.
NOTE: Verify the two relief doors (located on top of
the firebox) are properly seated on the gasket. The
doors should sit flush on the gasket, and should lift
easily from the seal around the opening.
ST720
Washer
Hex Head Bolt
ST721
Radiance
attach
front legs
7/30/02 djt
13