Mercedes-Benz C-Class Operator's Manual page 99

Using KEYLESS-GO
The driver's door and the door at which the han-
dle is used, must both be closed. The SmartKey
must be outside the vehicle. The gap between
the SmartKey and the corresponding door han-
dle should not be greater than 3 ft (1 m).
Touch recessed sensor surface : on the
X
door handle until the side windows and the
sliding sunroof or the panorama roof with
power tilt/sliding panel are fully closed.
Make sure you only touch recessed sensor
surface :.
Make sure that all the side windows and the
X
sliding sunroof or panorama roof with power
tilt/sliding panel are closed.
Vehicles with panorama roof with power
X
tilt/sliding panel: touch recessed sensor
surface : on the door handle again until the
roller sunblinds of the panorama roof with
power tilt/sliding panel close.
To interrupt convenience closing: release
X
recessed sensor surface : on the door han-
dle.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Pull the corresponding switch on the door
X
control panel until the side window is com-
pletely closed ( page 95).
Y
Hold the switch for an additional second.
X
If the side window opens again slightly:
Immediately pull the corresponding switch on
X
the door control panel until the side window is
completely closed (
Y
Hold the switch for an additional second.
X
If the respective side window remains closed
X
after the button is released, then it has been
set correctly. If this is not the case, repeat the
steps above.
Side windows
page 95).
Z
97