Mercedes-Benz C-Class Operator's Manual page 358

Towing and tow-starting
356
!
Vehicles with 4MATIC must not be towed
with either the front or the rear axle raised, as
doing so will damage the transmission.
Vehicles with 4MATIC may either be towed away
with both axles on the ground or be loaded up
and transported.
!
Vehicles with automatic transmission must
not be towed with the rear axle raised. The
vehicle/trailer combination may otherwise
swerve or even roll over.
Towing a vehicle with both axles on
the ground
The automatic transmission automatically shifts
to position P when you open the driver's or front-
passenger door or when you remove the Smart-
Key from the ignition lock. In order to ensure
that the automatic transmission stays in posi-
tion N when towing the vehicle, you must
observe the following points:
Make sure that the vehicle is stationary.
X
Turn the SmartKey to position 2 in the ignition
X
lock.
Depress and hold the brake pedal.
X
Shift the automatic transmission to position
X
N.
Leave the SmartKey in position 2 in the igni-
X
tion lock.
Release the brake pedal.
X
Release the electric parking brake.
X
Switch on the hazard warning lamps
X
( page 120).
Y
In order to signal a change of direction when
towing the vehicle with the hazard warning
lamps switched on, use the combination switch
as usual. In this case, only the indicator lamps
for the direction of travel flash. After resetting
the combination switch, the hazard warning
lamp starts flashing again.
Transporting the vehicle
PLUG-IN HYBRID vehicles
Transportation of the vehicle should only be car-
ried out by professional recovery companies.
4MATIC vehicles/vehicles with auto-
matic transmission
!
When the vehicle is loaded for transport, the
front and rear axles must be stationary and on
the same transportation vehicle. Positioning
over the connection point of the transport
vehicle is not permitted. The drive train may
otherwise be damaged.
All vehicles
!
You may only secure the vehicle by the
wheels, not by parts of the vehicle such as
axle or steering components. Otherwise, the
vehicle could be damaged.
The towing eye can be used to pull the vehicle
onto a trailer or transporter for transporting pur-
poses.
Turn the SmartKey to position 2 in the ignition
X
lock.
Shift the automatic transmission to position
X
N.
As soon as the vehicle has been loaded:
Prevent the vehicle from rolling away by
X
applying the electric parking brake.
Shift the automatic transmission to posi-
X
tion P.
Turn the SmartKey to position 0 in the ignition
X
lock and remove it.
Secure the vehicle.
X
Notes on 4MATIC vehicles
!
Vehicles with 4MATIC must not be towed
with either the front or the rear axle raised, as
doing so will damage the transmission.