Timer Ignition; Temperature Regulation - Toyotomi LC-43 Instruction Manual

arranged to ignite automatcally at a chosen time by use of a pre-set "Timer". This "Timer" can only be
set after the clock setting has been completed.
after that. The Timer Lamp and Digital Indicator will start blinking.
2. To set the "Timer" to the chosen igntion time, you should follow the same procedure as given earlier
for "Clock" time setting. After approximately 10 seconds, the digital indicator will return to "Clock"
mode, displaying the present time.
3. Your heater will now automatically start up the pre-set time.
4. If you wish to start up the heater at the pre-set time again, repeat the sameprocedure 1. mentioned
above.
NOTE: The pre-set time will remain so long as the heater receives electrical power. In the event of
power failure or disconnection of heater for more than 10 minutes, timer setting will be
cancelled.
NOTE: If normal ignition was used to set the heater burning (i.e. the heater is burning but the Timer
Lamp on the Indicator panel is out), pressing the Timer key will extinguish the heater, and
the heater will be put into the "Timer"mode.

TEMPERATURE REGULATION

1. Use the Adjustment keys (▼ hour / ▲ min.) to adjust the temperature.
2. Adjust the temperature using the key on the right (▲ min.) to set the
temperature to a higher setting and the key on the left (▼hour) to lower
the temperature.
3. Until the room temperature has reached the set temperature, the heater will burn ateither high or
medium burning mode. When the room temperature reaches or slightly exceeds the set
temperature, the heater will automatically shift to maintain the desired temperature.
6
TIMER
IGNITION
Your heater can be