Operation; Set Clock; Ignition - Toyotomi LC-43 Instruction Manual

CAUTION : Always make sure that there is sufficient ventilation.

SET CLOCK

It is only possible to set the correct time, when the
heater is connected to the mains and not burning.
1. Use the Adjustment Keys (▼hour/▲ min.) to set the
time.
2. To set the time, press "hour" and "min."set buttons.
Individual motions will increase the time by one
unit; holding continuously will raise either the
"hour" or "min." rapidly. After approximately 10
seconds the blinking will stop and the setting will be
locked. 5 Minutes after switching off the heater, the
information on the display will disappear and the heater will automatically switch into the stand-by
position.

IGNITION

1. Just press the button to ignite the heater. The button
will start blinking, indicating that the ignition
procedure has started. This will take a short while.
2. After this time heater will automaticallyignite and
The button will cease its flashing. The Operation
Lamp will remain alight so long as heater is burning.
NOTE: If using your heater for the first time, or after long term storage, ignition may not take place
on the first try. Press the
NOTE: Fuel pump may produce an audible operating noise at ignition. This is only temporary.

OPERATION

button again.
5