Troubleshooting; Clean Fuel Acceptance Fitting; Check For Fuel Leaks; Clean Louvers - Toyotomi LC-43 Instruction Manual

Using a vacuum cleaner, remove any dust from the fan cover at the back
of the heater.

3. Clean Fuel Acceptance Fitting

When dirt or dust accumulates in the fuel acceptance fitting, it should be
cleaned, Check fuel acceptance fitting each time your refuel.

4. Check for fuel leaks

Make it a habit to check for signs of fuel leakage. Wipe off any spilled fuel
on the sub tank and removable fuel tank.
Spilled fuel may cause odor or risk of fire.

5. Clean Louvers

Dust and stains should be wiped off louvers with a damp cloth. If dust and
stains are allowed to build up over a period of time, removal will become
difficult. Make it a point to wipe clean regularly.

TROUBLESHOOTING

Should problems arise during operation or ignition, use this chart to
determine the cause and the proper steps to take. Be sure to unplug heater
and allow to cool completely before taking corrective measures.
PROBLEM
POWER LAMP FAILS
TO TURN ON
NO IGNITION
CAUSE
—Disconnected power plug —
Incorrect wiring
—Circuit board malfunction
—Out of fuel
—Clogged air filter
—Use of inferior kerosene
(paraffin)
—Incorrect wiring
—Circuit board, ignition heater or
fuel pump malfunction
SOLUTION
—Plug into 230V AC outlet.
—Consult your dealer.
—Consult your dealer.
—Refuel
—Clean air filter.
—Remove fuel and refuel using fresh,
clear kerosene (paraffin).
—Consult your dealer.
—Consult your dealer.