6.9.6 Polishing (with vacuuming)
Initial use
Shutting down
Switch the programme selector switch (S2) to position "Polishing with vacuuming"
Suction turbine (M2) active
Speed reset suction turbine speed (M2) active, if set to "1" in the setup menu (option only)
FACT active if set to "1" in the setup menu
Red LED "Fault" is glowing continuous-
ly
After approx. 10 seconds of overload,
the following will be shut off
Brush motor
–
Solenoid valve water
–
Dosing pump detergent (optional)
–
Red LED "Fault" is blinking
Switch the programme selector switch
(S2) to position "OFF and perform star-
tup
LED "Battery" (green)
LED "Battery" (green)
Brush motor (M1) ready
Deadman switch (S3)
actuated?
Yes
Brush motor (M1) active
Yes Brush motor overload?
English 5.906-269.0 Rev. 00 (03/11)
No
No
63