Installing Colorado Backup For Windows 95 - HP Colorado 5GB Installation Manual

Installing Colorado Backup for Windows 95

NOTE: Do not use Colorado Backup for Windows 95 to backup Novell servers.
Colorado Backup for DOS can backup Novell 2.x and 3.x servers or Colorado
Backup for Windows (3.1 or 3.11) can backup Novell 3.x servers.
NOTE: Colorado Backup for Windows 95 can back up computers over your
Windows 95 and Windows for Workgroups networks. However, Colorado
Backup for Windows 95 will only back up the Windows 95 registry of the
computer to which your tape drive is attached. The Windows 95 registry of a
remote computer will not be backed up.
1. You will need two formatted, 3.5" (1.44 MB) diskettes labeled "Recovery
Disk #1" and "Recovery Disk #2" to use in step 12.
2. Connect the tape drive to your parallel port as described in "Connecting
the Hardware" on page 2. The drive must be attached to install and
configure the software.
3. Insert the software installation CD into your CD-ROM drive. If your
computer does not have a CD-ROM, see page 33.
4. If the first screen does not appear automatically, click the Start button on
the Windows 95 task bar, select Run, type D:\SETUP (where D: is your
CD-ROM's drive letter), then click on OK. The following screen appears:
5. Select the desired language or leave the default. Click on Next.
Installing the Software
21