HP Colorado 5GB Installation Manual page 6

6
7. Attach the cable's remaining connector to the tape drive and secure it by
Tape-drive data cable
Printer cable
(Only if you are sharing
the port with a printer)
If You Have Problems...
Installation Guide
tightening the retaining screws.
After connecting your tape drive and turning on your computer, the
computer should start (boot) as it normally does. If it does not, check the
following items:
Is the computer power cord plugged in?
Is each device plugged in and turned on?
Are all cables properly plugged into the back of your computer?
If you verify all of these and still have problems, try turning off your
computer. Wait at least 20 seconds before turning it back on.
If you have a printer connected to the HP Colorado 5GB tape drive,
turn off the computer's power. Disconnect the tape drive and the
printer. Reconnect only your tape drive to the parallel port, then turn
the computer on and start Colorado Backup. If tape drive works, it is
likely you have a conflict with the printer.